Difference between revisions of "Floodlights Do Not Turn Off"

Latest revision as of 23:28, 8 March 2007

Redirect to:

@@ Line 1: / Line 1: @@
-==Questions==
+#REDIRECT [[Floodlights Don't Turn Off]]
-'''Why do my floodlights turn on but do not turn off?'''
-==Answer==
-If the Motion Monitor is accidentally powered off (from a wall switch that controls the power to it or a loss of power) while the floodlights are on, they will stay on when power is reapplied.  To reset the Outdoor Motion Monitor, follow the instructions below.
-*Set RANGE control to MAX.
-*Set DUSK control to LIGHT.
-*Set TIME DELAY to 0.1.
-*Set THIS UNIT switch to SENSOR.
-*Turn off the power at the circuit breaker panel (in your breaker box).  Wait 10 seconds.
-*Turn power back on at the circuit breaker (the floodlights will be on just like they were before power was turned off).
-*Wait for 1 minute, and then walk in front of the Motion Detector.
-*Make sure that it does not see any other movement for 10 seconds, and check that the floodlights turn off.
-*Set RANGE, DUSK, and TIME DELAY controls as desired, following the instructions in the owner's manual.  Your Motion Detector Light Control is now ready to use.  NOTE:  When you first apply power to the Motion Detector, it will not start working until after a delay of 1 minute.
-===Related Articles===
-[[Dual Floodlight Motion Detector Set-Up]]
-:Key Topics: flood,instructions,set,up,light,dual
-[[Category:troubleshooting]]