Difference between revisions of "Fluorescent Lights"
(→Answer) |
X10douglas (talk | contribs) |
||
| (8 intermediate revisions by 2 users not shown) | |||
| Line 5: | Line 5: | ||
==Answer== | ==Answer== | ||
| − | The main reason why standard X10 wall switch modules cannot be used to control a fluorescent fixture is because it is a two-wire device and is therefore wired in series with the load. The control signals which are transmitted onto your house wiring have to pass through the incandescent lamp (load). However, a fluorescent light contains a ballast which acts as a block to the X10 signals and makes it impossible to control the switch remotely. Also, this ballast is an inductive load (a coil), and controlling such a load could permanently damage the wall switch module. This is why the standard X10 wall switches (WS467 and WS12A) should NOT be used to control any kind of appliance (such as a ceiling fan). | + | The main reason why standard X10 wall switch modules cannot be used to control a fluorescent fixture is because it is a two-wire device and is therefore wired in series with the load. The control signals which are transmitted onto your house wiring have to pass through the incandescent lamp (load). However, a fluorescent light contains a ballast which acts as a block to the X10 signals and makes it impossible to control the switch remotely. Also, this ballast is an inductive load (a coil), and controlling such a load could permanently damage the wall switch module. This is why the standard X10 wall switches ([[WS467]] and [[WS12A]]) should NOT be used to control any kind of appliance (such as a ceiling fan). |
To control fluorescent fixtures use the X10 | To control fluorescent fixtures use the X10 | ||
| − | [http://www. | + | |
| − | [http://www. | + | *[[WS13A]] - [http://www.x10.com/ws13a.html X10 Non-dimming Decorator Wall Switch] or |
| − | Note that these versions require a neutral connection and are therefore recommended for installation only by a qualified electrician. | + | |
| + | *[[XPS4]] - [http://www.x10.com/xps4.html X10PRO Non-dimming Wall Switch]. | ||
| + | |||
| + | |||
| + | '''''Note''' that these versions require a neutral connection and are therefore recommended for installation only by a qualified electrician.'' | ||
| + | |||
| + | |||
===Related Articles=== | ===Related Articles=== | ||
| Line 18: | Line 24: | ||
[[Phase Coupling]] | [[Phase Coupling]] | ||
| − | |||
| − | + | ||
| + | |||
[[Category:troubleshooting]] | [[Category:troubleshooting]] | ||
[[Category:frequently asked questions]] | [[Category:frequently asked questions]] | ||
Latest revision as of 21:38, 30 December 2015
Question
Why can't I use an X10 Wall Switch Module to control a fluorescent light?
Answer
The main reason why standard X10 wall switch modules cannot be used to control a fluorescent fixture is because it is a two-wire device and is therefore wired in series with the load. The control signals which are transmitted onto your house wiring have to pass through the incandescent lamp (load). However, a fluorescent light contains a ballast which acts as a block to the X10 signals and makes it impossible to control the switch remotely. Also, this ballast is an inductive load (a coil), and controlling such a load could permanently damage the wall switch module. This is why the standard X10 wall switches (WS467 and WS12A) should NOT be used to control any kind of appliance (such as a ceiling fan).
To control fluorescent fixtures use the X10
Note that these versions require a neutral connection and are therefore recommended for installation only by a qualified electrician.
Related Articles
Switch Turns On But Not Off
Modules Work in Some Locations but not Others
Phase Coupling