Fluorescent Lights

From X10Wiki
Revision as of 22:16, 16 March 2006 by X10admin (talk | contribs) (Perl Automatic Add)
Jump to navigation Jump to search

Questions Why can't I use an X10 Wall Switch Module to control a fluorescent light? Answer The main reason why standard X10 wall switch modules cannot be used to control a fluorescent fixture is because it is a two wire device and is hence wired in series with the load. The control signals which are transmitted onto your house wiring have to pass through the incandescent lamp (load). However, a fluorescent light contains a ballast which acts as a block to the X10 signals and makes it impossible to control the switch remotely. Also this ballast is an inductive load (a coil), and controlling such a load could permanently damage the wall switch module. This is why the standard X10 wall switches (WS467 and WS12A) should NOT be used to control any kind of appliance (such as a ceiling fan). To control fluorescent fixtures use the X10 [a href="http://www.activehomepro.com/accessories/acc_wallswitch_ws13a.html"] Non-dimming Decorator Wall Switch (WS13A) or [a href="http://www.activehomepro.com/accessories/pro/xps3_iw_wa1_s.html"] X10 Pro Non-dimming Wall Switch (XPS3). Note that these versions require a neutral connection and are therefore recommended for installation only by a qualified electrician. Related Articles [img src="http://site.x10.com/?Z3gxT2tiYXNlYXJ0aWNsZTEuZGF0=RND%7Ckbasearticle"]