Difference between revisions of "Making a PowerHorn Macro"

From X10Wiki
Jump to: navigation, search
(Answer)
Line 12: Line 12:
 
*Appliance Module On
 
*Appliance Module On
  
You should repeat this sequence of steps at least 4 times. After building this macro, go to the room in which it resides, then click its Run Macro button. The siren should go off.
+
You should repeat this sequence of steps at least 4 times. After building this macro, go to the room in which it resides, then click its Run Macro button. The siren should go off. About 5 seconds after the macro finishes running, the siren should stop sounding.

Revision as of 22:56, 4 March 2009

Question

How can I control a PowerHorn siren from ActiveHome Pro?

Answer

Plug in the PowerHorn siren, then define an AM466 Three-Pin Appliance Module in ActiveHome Pro at the address of the PowerHorn. Build a Macro with a different Trigger Code than the PowerHorn's address. Put the following steps in the macro:

  • Delay 2 Seconds
  • Appliance Module On
  • Delay 2 Seconds
  • Appliance Module On

You should repeat this sequence of steps at least 4 times. After building this macro, go to the room in which it resides, then click its Run Macro button. The siren should go off. About 5 seconds after the macro finishes running, the siren should stop sounding.