Difference between revisions of "Newer Wall Switches and Preset Dim"

From X10Wiki
Jump to: navigation, search
m (Controlling From Active Home Pro)
Line 21: Line 21:
 
#Right-click on the module you want to edit then left-click on Edit Module:<br>[[Image:Module-rightclickmenu.JPG]]
 
#Right-click on the module you want to edit then left-click on Edit Module:<br>[[Image:Module-rightclickmenu.JPG]]
 
#Change the Type of Module to Lamps and the Module to 2-Way Lamp Module:<br>[[Image:Editmodule.JPG]]
 
#Change the Type of Module to Lamps and the Module to 2-Way Lamp Module:<br>[[Image:Editmodule.JPG]]
#Click OK and verify that a Poll button now appears on the module:<br>[[Image:Pollbutton.JPG]]
+
#Click OK and verify that a Poll button now appears on the module.<br> (Note however that the WS467 will not respond to a poll since it is only a 1-way device.)<br>[[Image:Pollbutton.JPG]]

Revision as of 21:56, 19 October 2009

Question

I bought an X10 dimming wall switch in 2007 or later and its manual does not seem to describe its behavior correctly. Do you have updated instructions?

Answer

Most X10 dimming wall switches manufactured in 2007 or later have SoftStart and Preset Dim features added. By default, tapping the switch will bring the switch on at full brightness. You can set the switch to come on at a dim level instead.

Setting Preset Dim

Tap the switch so it comes on at full brightness. Press and hold the switch; the light will dim. Release the switch at the desired level. Tapping the switch will now alternate between off and dimmed.

Clearing Preset Dim

If the light is off, tap the switch once so it is on but dimmed. Press and hold the switch for 5 seconds; the light will dim further until it is almost off. Release the switch, then press and hold it for five more seconds; the light should come on at full brightness.

Controlling From Active Home Pro

Call your Preset Dim modules and wall switches LM14A Two-Way Lamp Modules for best control results in ActiveHome Pro, using the procedure below. Please note that the Timer Test in the ActiveHome Pro Intro Wizard will not control Preset Dim modules via timer.

  1. Right-click on the module you want to edit then left-click on Edit Module:
    Module-rightclickmenu.JPG
  2. Change the Type of Module to Lamps and the Module to 2-Way Lamp Module:
    Editmodule.JPG
  3. Click OK and verify that a Poll button now appears on the module.
    (Note however that the WS467 will not respond to a poll since it is only a 1-way device.)
    Pollbutton.JPG