Difference between revisions of "Problems Setting Motion Sensors"
Jump to navigation
Jump to search
(Perl Automatic Add) |
|||
| Line 1: | Line 1: | ||
| − | + | Questions | |
| − | + | What should I do when my VCR Commander will not accept Motion Sensor codes during programming? | |
| − | [ | + | Answer |
| + | If you have trouble programming a motion sensor code into your VCR Commander, try the following: | ||
| + | *Put new batteries in each Motion Sensor. | ||
| + | *Double-check that the Motion Sensor(s) has/have been programmed properly. | ||
| + | After verifying each of the above steps, clear the Motion Sensor memory in your VCR Commander and re-learn the X10 radio frequency codes. | ||
| + | Related Articles | ||
| + | [img src="http://site.x10.com/?Z3gxT2tiYXNlYXJ0aWNsZTEuZGF0=RND|kbasearticle"] | ||
Revision as of 22:13, 16 March 2006
Questions What should I do when my VCR Commander will not accept Motion Sensor codes during programming? Answer If you have trouble programming a motion sensor code into your VCR Commander, try the following:
- Put new batteries in each Motion Sensor.
- Double-check that the Motion Sensor(s) has/have been programmed properly.
After verifying each of the above steps, clear the Motion Sensor memory in your VCR Commander and re-learn the X10 radio frequency codes. Related Articles [img src="http://site.x10.com/?Z3gxT2tiYXNlYXJ0aWNsZTEuZGF0=RND%7Ckbasearticle"]