Difference between revisions of "Setting Up Door/Window Sensors"

From X10Wiki
Jump to navigation Jump to search
Line 11: Line 11:
 
*Press and hold the TEST button for about a second. The LED indicator light flashes twice when you release it. This confirms it has generated a new security code.
 
*Press and hold the TEST button for about a second. The LED indicator light flashes twice when you release it. This confirms it has generated a new security code.
 
*Set the slider switch on the console to INSTALL.
 
*Set the slider switch on the console to INSTALL.
*Press the TEST button on the Door/Window sensor or open the Door/Window that it is attached to. The console chimes once to confirm and the next available zone LED lights.
+
*Press the TEST button on the Door/Window sensor or open the Door/Window it is attached to. The console chimes once to confirm and the next available zone LED lights.
 
*Return the slider switch on the console to the RUN1 or RUN2 position.
 
*Return the slider switch on the console to the RUN1 or RUN2 position.
 +
 
===Testing the Door/Window sensor===
 
===Testing the Door/Window sensor===
 
*Set the slider switch on the security console to RUN2.
 
*Set the slider switch on the security console to RUN2.

Revision as of 23:05, 2 May 2006

Introduction

This guide should help you in quickly setting up X10 Door/Window Sensors.

Setup

Installing the Door/Window Sensor

  • Attach the Door/Window sensor to the wall using the mounting screws provided.
  • Fit the Door/Window sensor as high as possible at the top of the door/window.
  • Make sure the arrows on the magnetic switch halves are facing each other and that they separate cleanly when the door or window is opened.
  • Set the DELAY slider switch to MIN to always trigger the alarm instantly, or to MAX to trigger the alarm after a preset entry delay when the system is armed in DELAY mode (see the alarm manual for Delay Mode instructions).

Registering the Door/Window Sensor with the Security Console

  • Fit two AA Alkaline batteries in the battery compartment.
  • Press and hold the TEST button for about a second. The LED indicator light flashes twice when you release it. This confirms it has generated a new security code.
  • Set the slider switch on the console to INSTALL.
  • Press the TEST button on the Door/Window sensor or open the Door/Window it is attached to. The console chimes once to confirm and the next available zone LED lights.
  • Return the slider switch on the console to the RUN1 or RUN2 position.

Testing the Door/Window sensor

  • Set the slider switch on the security console to RUN2.
  • Open the door or window with the sensor attached. The console chimes to acknowledge the sensor is tripped and the zone LED lights.

Note: As with all radio frequency transmitter devices, electrical fields, metal doors or door/window frames, and appliances can cause interference that decreases the strength of a transmitted signal. Re-orienting the sensor or putting the console in a higher location may increase your ability to send and receive the necessary signals.

Related Articles

Extending the Range of Security System Sensors and Remotes

Key Topics: security,remote,sensor,range,control,extendsion,extend,repeater,rf,radio,frequency
Relates to: DS700,DC8700,PA5800,PA9200

Identifying and Fixing Low Battery Warnings

Key Topics: security,console,beep,zone,light,flash,battery,low
Relates to: DS7000,PS561

Troubleshooting Zone Lights Indicators

Key Topics: zone,sensor,battery,led,light,beep,flash,problem
Relates to: DS700,DC8700