Difference between revisions of "Setting Up the Remote Chime"

From X10Wiki
Jump to navigation Jump to search
 
 
(6 intermediate revisions by 4 users not shown)
Line 1: Line 1:
== EDITME ==
+
==Introduction==
  
[[category: needed pages]]
+
This guide should help you in quickly setting up the X10 Remote Chime.
 +
 
 +
==Setup==
 +
 
 +
*Set the House code dial on the SC546A Remote Chime to the same letter as your X10 Controller (TM751 Transceiver Module, MT10A Mini Timer, etc.).
 +
 
 +
 
 +
*Set the Unit Code dial on the SC546A to any unused number between 1 and 16. If you are using it with a Motion Sensor, set it to the same House and Unit Code as your Motion Sensor (MS13A/MS14A/MS16A) and the same House code as your Transceiver (TM751)--if you are using a Transceiver as opposed to the ActiveHome Professional software interface.
 +
 
 +
 
 +
*Plug the SC546A Remote Chime into any unused outlet (not one that is controlled by a wall switch, in case the switch accidentally gets turned off).
 +
 
 +
 
 +
*To test the SC546A, press the number button (on any X10 Controller) corresponding to its Unit Code. Or walk past a Motion Sensor. The Motion Sensor sends a signal to the TM751 (or CM15A interface), which retransmits it over your house wiring to the SC546A. The Remote Chime then sounds.
 +
 
 +
 
 +
 
 +
 
 +
===Related Articles===
 +
 
 +
[[Remote Chime Module]]
 +
 
 +
[[Category:frequently asked questions]]

Latest revision as of 20:26, 29 May 2014

Introduction

This guide should help you in quickly setting up the X10 Remote Chime.

Setup

  • Set the House code dial on the SC546A Remote Chime to the same letter as your X10 Controller (TM751 Transceiver Module, MT10A Mini Timer, etc.).


  • Set the Unit Code dial on the SC546A to any unused number between 1 and 16. If you are using it with a Motion Sensor, set it to the same House and Unit Code as your Motion Sensor (MS13A/MS14A/MS16A) and the same House code as your Transceiver (TM751)--if you are using a Transceiver as opposed to the ActiveHome Professional software interface.


  • Plug the SC546A Remote Chime into any unused outlet (not one that is controlled by a wall switch, in case the switch accidentally gets turned off).


  • To test the SC546A, press the number button (on any X10 Controller) corresponding to its Unit Code. Or walk past a Motion Sensor. The Motion Sensor sends a signal to the TM751 (or CM15A interface), which retransmits it over your house wiring to the SC546A. The Remote Chime then sounds.



Related Articles

Remote Chime Module