Difference between revisions of "Timers Or Macros Not Working In Activehome Pro"

From X10Wiki
Jump to navigation Jump to search
Line 13: Line 13:
 
==Related Articles==
 
==Related Articles==
 
[[Advanced Layout and Repeat]]
 
[[Advanced Layout and Repeat]]
 +
 +
[[Setting The CM15A to send RF Commands]]
  
 
[[Category:troubleshooting]]
 
[[Category:troubleshooting]]
  
 
[[Category:software]]
 
[[Category:software]]

Revision as of 19:58, 9 July 2007

Question

I can control my lights/appliances through ActiveHome Pro manually, so why are my timers not working?

Answer

Macros and timers are sent in a compressed format that is more vulnerable to interference. If you can control some lights, but others are intermittent, not responding, or respond to regular signals but not macros or timers, then generally the problem will fall into one of two categories: phase issues and line noise.

If you find that it is not a phase issue or line noise go to your 'Timer Designer' and click on 'Advanced Layout' on the right hand side. Within the timer check the box for 'Repeat' in the lower right hand corner. This will send the command multiple times when the timer runs.

If this fails, please go into the Help menu and select Run Intro Wizard. If the timer test in the Intro Wizard fails and you have absolutely ruled out phase and line noise problems, your CM15A may have an issue.

Related Articles

Advanced Layout and Repeat

Setting The CM15A to send RF Commands