Troubleshooting Audio Quality

From X10Wiki
Revision as of 19:16, 20 July 2006 by Ericb (talk | contribs) (→‎Answer)
Jump to navigation Jump to search

Question

The sound isn't clear when I use my X10 wireless kit. How do I fix it?

Answer

First, adjust the antennas on the receiver and the video transmitter or camera so they point toward each other. The faces of their antennas are marked with four squares or with a bump. You can also try moving the video receiver itself higher off the floor. Sometimes moving it just a foot can make a big difference.

If the sound still does not improve after adjusting the antennas and receiver position, try changing the channels on the transmitter/camera and receiver. To do this, check the channel switch on the bottom of each unit, making sure they are set to the same letter (A, B, C, or D). The A, B, C, and D channel switch on each camera is located under the gray rubber plug next to the lens. Try different letters to see if the sound improves.

You may still have trouble getting a clear signal if there is something in the area using the same radio frequency as the X10 hardware. The following things can interfere with audio transmission: 2.4 gigahertz cordless phones, wireless networks, baby monitors, and microwave ovens. If you have any of these, turn them off to see if the problem goes away. X10 cameras and Video Senders use the following frequencies:

  • Channel A: 2.411 GHz
  • Channel B: 2.434 GHz
  • Channel C: 2.453 GHz
  • Channel D: 2.473 GHz

We recommend using a frequency on a non-X10 device that is farthest from channel A or D, depending on which side of the band the other device is transmitting.

If your picture or audio has been working fine, then suddenly becomes distorted or fuzzy, look for new electronic products in your house that might be causing interference.

Related Articles

Troubleshooting Volume Problems

Key Topics: volume, sound, mute, loud

Relates to: MK10A, MK11A, MK12A, LOLA1, LOLA2, LOLA3, CM19A, UR89A, VR30A, VT42A, VR31A, XX16A, XX17A, XX20A