Wrist Watch Panic Button

From X10Wiki
Revision as of 19:36, 3 July 2014 by X10douglas (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

WR10A: Wrist Watch Panic Button

wr10a


Product Pages


Specifications

Weight
0.32 lbs.
Power Supply
CR2016 Lithium 3V

NOTE: The WR10A will work with all Security Consoles and Personal Voice Dialer Consoles currently sold by X10.

Installation

The WR10A comes with a CR2016 Lithium 3V battery already installed.

  1. Set the INSTALL/RUN switch on your Console to INSTALL.
  2. Press the face of the WR10A and hold for two seconds. The Console will emit a tone.
  3. Set the slide switch on the console to RUN.


Installation Note

If you do not hear a beep in step 2 above, remove the battery and then hold down the watch face for 2 seconds. Refit the battery and press ARM again then hold down the watch face for 2 seconds. The WR10A will now have a new code; go back to step 1.


Operation

  1. Set the slide switch on the console to RUN.
  2. Press the face of the WR10A and hold for one second to trip the Panic Alarm. Press twice quickly to stop the Alarm.


Replacing Batteries

Remove the back cover and replace the battery with a CR2016 Lithium 3V battery. We recommend doing this in a well-lit area and completely removing the new battery from its packaging before taking the old battery out. After replacing the battery, please test the alarm:

  1. Set the slide switch on the console to RUN.
  2. Press the face of the WR10A and hold for one second to trip the Panic Alarm. If the alarm goes off, the watch is still installed in the console and you do not need to do anything else. Press twice quickly to stop the Alarm.


If the console does not trip

  1. Set the INSTALL/RUN switch on your Console to INSTALL.
  2. Press the face of the WR10A and hold for three seconds. The Console will emit a tone.
  3. Set the slide switch on the console to RUN.