Difference between revisions of "Problems Setting Motion Sensors"
Jump to navigation
Jump to search
(Perl Automatic Add) |
X10douglas (talk | contribs) |
||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | ==Question== | |
| − | What should I do when my VCR Commander will not accept Motion Sensor codes during programming? | + | |
| − | Answer | + | '''What should I do when my VCR Commander will not accept Motion Sensor codes during programming?''' |
| + | |||
| + | ==Answer== | ||
| + | |||
If you have trouble programming a motion sensor code into your VCR Commander, try the following: | If you have trouble programming a motion sensor code into your VCR Commander, try the following: | ||
| + | |||
*Put new batteries in each Motion Sensor. | *Put new batteries in each Motion Sensor. | ||
*Double-check that the Motion Sensor(s) has/have been programmed properly. | *Double-check that the Motion Sensor(s) has/have been programmed properly. | ||
| + | |||
| + | |||
After verifying each of the above steps, clear the Motion Sensor memory in your VCR Commander and re-learn the X10 radio frequency codes. | After verifying each of the above steps, clear the Motion Sensor memory in your VCR Commander and re-learn the X10 radio frequency codes. | ||
| − | + | ||
| − | [ | + | |
| + | |||
| + | [[Category:troubleshooting]] | ||
Latest revision as of 22:07, 28 May 2014
Question
What should I do when my VCR Commander will not accept Motion Sensor codes during programming?
Answer
If you have trouble programming a motion sensor code into your VCR Commander, try the following:
- Put new batteries in each Motion Sensor.
- Double-check that the Motion Sensor(s) has/have been programmed properly.
After verifying each of the above steps, clear the Motion Sensor memory in your VCR Commander and re-learn the X10 radio frequency codes.