Difference between revisions of "Setting Up the Remote Chime"
X10MichaelC (talk | contribs) |
(Perl Automatic Add) |
||
| Line 1: | Line 1: | ||
| − | + | Questions | |
| − | + | Setting Up the Remote Chime | |
| − | [ | + | Answer |
| + | *Set the House code dial on the SC546A Remote Chime to the same letter as your X10 | ||
| + | Controller (TM751 Transceiver Module, MT10A Mini Timer, etc.). | ||
| + | *Set the Unit Code dial on the SC546A to any unused number between 1 | ||
| + | & 16. If you are using it with a Motion Sensor, set it to the same House code | ||
| + | and Unit Code as your Motion Sensor (MS13A/MS14A/MS16A) and the | ||
| + | same House code as your Transceiver (TM751)--if you are using a Transceiver as opposed to the ActiveHome Professional software interface. | ||
| + | *Plug the SC546A Remote Chime into any unused outlet (not one that is controlled | ||
| + | by a wall switch, in case the switch accidentally gets turned off). | ||
| + | *To test the SC546A, press the number button (on any X10 Controller) | ||
| + | corresponding to its Unit Code. Or walk past a Motion | ||
| + | Sensor. The Motion Sensor sends a signal to the TM751 (or CM15A interface), which retransmits it | ||
| + | over your house wiring to the SC546A. The Remote Chime then sounds. | ||
| + | Related Articles | ||
| + | [img src="http://site.x10.com/?Z3gxT2tiYXNlYXJ0aWNsZTEuZGF0=RND|kbasearticle"] | ||
Revision as of 22:17, 16 March 2006
Questions Setting Up the Remote Chime Answer
- Set the House code dial on the SC546A Remote Chime to the same letter as your X10
Controller (TM751 Transceiver Module, MT10A Mini Timer, etc.).
- Set the Unit Code dial on the SC546A to any unused number between 1
& 16. If you are using it with a Motion Sensor, set it to the same House code and Unit Code as your Motion Sensor (MS13A/MS14A/MS16A) and the same House code as your Transceiver (TM751)--if you are using a Transceiver as opposed to the ActiveHome Professional software interface.
- Plug the SC546A Remote Chime into any unused outlet (not one that is controlled
by a wall switch, in case the switch accidentally gets turned off).
- To test the SC546A, press the number button (on any X10 Controller)
corresponding to its Unit Code. Or walk past a Motion Sensor. The Motion Sensor sends a signal to the TM751 (or CM15A interface), which retransmits it over your house wiring to the SC546A. The Remote Chime then sounds. Related Articles [img src="http://site.x10.com/?Z3gxT2tiYXNlYXJ0aWNsZTEuZGF0=RND%7Ckbasearticle"]