Difference between revisions of "Problems Learning IR Codes"
Jump to navigation
Jump to search
(Perl Automatic Add) |
|||
| Line 1: | Line 1: | ||
| − | == | + | Questions |
| − | + | What should I do when my VCR Commander will not accept IR codes during programming? | |
| − | [[ | + | Answer |
| + | If you are having trouble getting the VCR Commander to accept input from your remote, try the following: | ||
| + | *Verify that the VCR Commander is connected to a functional outlet. | ||
| + | *Check that the IR emitter cable is NOT connected to it. | ||
| + | *Make sure that the batteries in VCR remote are no more than six months old. | ||
| + | *Aim the VCR remote at IR target on the back of the VCR Commander when sending commands. | ||
| + | *Always hold the VCR remote within one inch of this IR target. | ||
| + | *See if the UX21A/UX23A VCR Commander or VCR Commander II has been properly entered into �Learn IR� mode. | ||
| + | After verifying each of the above steps, clear the IR memory in the VCR Commander and attempt to relearn the IR codes once more. | ||
| + | '''#4:''' | ||
| + | [img src="http://graphics.x10.com/images_knowledgebase/a00044_01.jpg" border=2] | ||
| + | Related Articles | ||
| + | [a href="/kbase/articles/a00039.html"]a00039[/a] : Setting Up and Learning with VCR Commander[BR] | ||
| + | Key Topics: ir, learn, command, commander, play, stop, record, remote, infrared | ||
| + | Relates to: | ||
| + | UX21A, UX23A, MS12A, MS13A, MS14A, MS16A | ||
| + | [img src="http://site.x10.com/?Z3gxT2tiYXNlYXJ0aWNsZTEuZGF0=RND|kbasearticle"] | ||
Revision as of 22:13, 16 March 2006
Questions What should I do when my VCR Commander will not accept IR codes during programming? Answer If you are having trouble getting the VCR Commander to accept input from your remote, try the following:
- Verify that the VCR Commander is connected to a functional outlet.
- Check that the IR emitter cable is NOT connected to it.
- Make sure that the batteries in VCR remote are no more than six months old.
- Aim the VCR remote at IR target on the back of the VCR Commander when sending commands.
- Always hold the VCR remote within one inch of this IR target.
- See if the UX21A/UX23A VCR Commander or VCR Commander II has been properly entered into �Learn IR� mode.
After verifying each of the above steps, clear the IR memory in the VCR Commander and attempt to relearn the IR codes once more.
#4:
[img src="
" border=2]
Related Articles
[a href="/kbase/articles/a00039.html"]a00039[/a] : Setting Up and Learning with VCR Commander[BR]
Key Topics: ir, learn, command, commander, play, stop, record, remote, infrared
Relates to:
UX21A, UX23A, MS12A, MS13A, MS14A, MS16A
[img src="http://site.x10.com/?Z3gxT2tiYXNlYXJ0aWNsZTEuZGF0=RND%7Ckbasearticle"]