Difference between revisions of "Wrist Watch Panic Button"
Jump to navigation
Jump to search
X10douglas (talk | contribs) |
X10douglas (talk | contribs) |
||
| Line 6: | Line 6: | ||
==Product Pages== | ==Product Pages== | ||
| − | + | *[http://www.x10.com/wr10aw.html Purchase WR10A-W] | |
| − | *[http://www.x10.com/ | + | *[http://www.x10.com/wr10ab.html Purchase WR10A-B] |
| − | *[http://www.x10.com/ | ||
| Line 14: | Line 13: | ||
;Weight: 0.32 lbs. | ;Weight: 0.32 lbs. | ||
| − | ;Power Supply: | + | ;Power Supply: CR2016 Lithium 3V |
'''NOTE''': The WR10A will work with all Security Consoles and Personal Voice Dialer Consoles currently sold by X10. | '''NOTE''': The WR10A will work with all Security Consoles and Personal Voice Dialer Consoles currently sold by X10. | ||
Revision as of 02:05, 11 June 2014
WR10A: Wrist Watch Panic Button
Product Pages
Specifications
- Weight
- 0.32 lbs.
- Power Supply
- CR2016 Lithium 3V
NOTE: The WR10A will work with all Security Consoles and Personal Voice Dialer Consoles currently sold by X10.
Installation
The WR10A comes with a CR2016 Lithium 3V battery already installed.
- Set the INSTALL/RUN switch on your Console to INSTALL.
- Press the face of the WR10A and hold for two seconds. The Console will emit a tone.
- Set the slide switch on the console to RUN.
Installation Note
If you do not hear a beep in step 2 above, remove the battery and then hold down the watch face for 2 seconds. Refit the battery and press ARM again then hold down the watch face for 2 seconds. The WR10A will now have a new code; go back to step 1.
Operation
- Set the slide switch on the console to RUN.
- Press the face of the WR10A and hold for one second to trip the Panic Alarm. Press twice quickly to stop the Alarm.
Replacing Batteries
Remove the back cover and replace the battery with a CR2016 Lithium 3V battery. We recommend doing this in a well-lit area and completely removing the new battery from its packaging before taking the old battery out. After replacing the battery, please test the alarm:
- Set the slide switch on the console to RUN.
- Press the face of the WR10A and hold for one second to trip the Panic Alarm. If the alarm goes off, the watch is still installed in the console and you do not need to do anything else. Press twice quickly to stop the Alarm.
If the console does not trip
- Set the INSTALL/RUN switch on your Console to INSTALL.
- Press the face of the WR10A and hold for three seconds. The Console will emit a tone.
- Set the slide switch on the console to RUN.
