Video Sender Interference
Questions
Why isn't the picture on my Video Sender clear?
Why do I only see white lines?
Answer
Other 5.8 GHz devices can distort the Video Transmitter and Receiver's picture and/or cause buzzing in the audio. If you are experiencing interference between the Video Transmitter and Receiver and some other equipment that uses 5.8 GHz, you might want to check the other device's owner's manual for the frequencies of each channel that it uses.
X10 cameras and Video Senders use the following frequencies:
- Channel A: 5.741 - 5.759 GHz
- Channel B: 5.761 - 5.779 GHz
- Channel C: 5.781 - 5.799 GHz
- Channel D: 5.801 - 5.819 GHz
We recommend using a frequency on the other device that is farthest from channel A or D, depending on which side of the band the other device is transmitting. You need to match the A-D switch on the Video Receiver with the one on the Video Transmitter.
If you are still experiencing interference, here are some suggestions for improving the signal.
- Move the Video Transmitter. If all else fails, walk around with it while someone else monitors your signal strength on your TV or PC.
- Change channels of your other 5.8 GHz devices. If you have a neighbor with a 5.8 GHz wireless setup of some kind, you may be operating on the same channel. See if they would possibly change their frequency.
- If your phone is using a 5.8 GHz signal, you could possibly change phones. Consider a 2.4 GHz or 900MHz phone.
- Check for wireless obstructions such as ceramic tile, concrete, brick, stucco--anything that can shorten the signal strength.
- It's possible for strong interference sources at different frequencies to affect the signal- try checking your 2.4GHz devices. Also, microwaves will often interfere when they are running- moving them away from the Receiver will lessen this.