Setting Up the Remote Chime

From X10Wiki
Revision as of 22:17, 16 March 2006 by X10admin (talk | contribs) (Perl Automatic Add)
Jump to navigation Jump to search

Questions Setting Up the Remote Chime Answer

  • Set the House code dial on the SC546A Remote Chime to the same letter as your X10

Controller (TM751 Transceiver Module, MT10A Mini Timer, etc.).

  • Set the Unit Code dial on the SC546A to any unused number between 1

& 16. If you are using it with a Motion Sensor, set it to the same House code and Unit Code as your Motion Sensor (MS13A/MS14A/MS16A) and the same House code as your Transceiver (TM751)--if you are using a Transceiver as opposed to the ActiveHome Professional software interface.

  • Plug the SC546A Remote Chime into any unused outlet (not one that is controlled

by a wall switch, in case the switch accidentally gets turned off).

  • To test the SC546A, press the number button (on any X10 Controller)

corresponding to its Unit Code. Or walk past a Motion Sensor. The Motion Sensor sends a signal to the TM751 (or CM15A interface), which retransmits it over your house wiring to the SC546A. The Remote Chime then sounds. Related Articles [img src="http://site.x10.com/?Z3gxT2tiYXNlYXJ0aWNsZTEuZGF0=RND%7Ckbasearticle"]

Retrieved from "https://kbase.x10.com/index.php?title=Setting_Up_the_Remote_Chime&oldid=1702"