Difference between revisions of "Adding A Switch To A Door Sensor"

From X10Wiki
Jump to navigation Jump to search
Line 14: Line 14:
  
 
[[Image:dwmag.jpg]]
 
[[Image:dwmag.jpg]]
 +
 +
==Related Articles==
 +
 +
[[Experiment With Magnet Placement]]

Revision as of 22:14, 22 December 2009

Questions

I have a double window or door; do I need to use two Door/Window Sensors?

How can I add an extra magnet switch to a Door/Window Sensor?

Can I use another sensor with the Protector Plus like a water level sensor?

Answer

It is pretty simple to add another magnet switch to a Door/Window Sensor. The magnet switch has two screw terminals on it. Normally, one magnet switch is wired to the terminals. Whenever the switch opens up or a wire is cut, the sensor sounds the alarm because power is not flowing between the terminals.

To add a switch to a sensor, unscrew one of the two terminals and take the sensor wire out. Get a length of wire; attach it to the free screw terminal, then attach the other end to a screw terminal on the new magnet switch. Connect the free wire from the sensor module to the other screw terminal on the new magnet switch. You now have a loop of wire with two switches in it. If either switch is tripped, the alarm will go off.

You can call 800-675-3044 to purchase extra magnet switches; ask for part number DW-MAG ($5/ea.) You can also substitute any normally-closed sensor (NC) made for a wired security system.

Dwmag.jpg

Related Articles

Experiment With Magnet Placement