Circuit Interrupters And X10

From X10Wiki
Revision as of 22:24, 16 April 2014 by X10douglas (talk | contribs)
Jump to navigation Jump to search


I have a GFI / GFCI outlet- can I control this with X10?

I have an arc-fault circuit breaker- can I control devices on this breaker with X10?



The arc-fault circuit interrupter (AFCI) should not be confused with the GFCI or ground fault circuit interrupter. The GFCI is designed to protect people from severe or fatal electric shocks while the AFCI protects against fires caused by arcing faults. The GFCI also can protect against some electrical fires by detecting arcing and other faults to ground but cannot detect hazardous across-the-line arcing faults that can cause fires.

A ground fault is an unintentional electric path diverting current to ground. Ground faults occur when current leaks from a circuit. How the current leaks is very important. If a person’s body provides a path to ground for this leakage, the person could be injured, burned, severely shocked, or electrocuted.

The National Electrical Code requires GFCI protection for receptacles located outdoors; in bathrooms, garages, kitchens, crawl spaces and unfinished basements; and at certain locations such as near swimming pools.

See for more information.


Generally, AFCI breakers will absorb some of the X10 powerline signal. Many customers have reported good results by adding an XPCR coupler-repeater at the breaker box. If you have ActiveHome Pro, you can install a TM751 module and use the procedure here to control devices on that breaker.


GFCI outlets will significantly absorb or block X10 signals. Consider using a spare TM751 module controlled via remote; you can use ActiveHome Pro to control that device via timed radio commands.

Work Around

  • Purchase a GFCI power strip like ones found here.
  • Into which you will plug an AM466 3-pin Appliance module found here.
  • As well as a TM751 Wireless Transceiver Module found here.
  • You'll also need one of our wireless controllers found here here.

  1. Plug your GFCI power strip into your GFI outlet
  2. Plug the device you'd like to control into the AM466 appliance module
  3. Plug the AM466 into the GFCI power strip
  4. Plug the TM751 into the GFCI power strip
  5. Place your X10 wireless controller where convenient (within 100ft of the TM751).