IconRemote For IR or RF X10 Control

From X10Wiki
Revision as of 20:24, 23 March 2007 by Ericb (talk | contribs) (→‎Answer)
Jump to navigation Jump to search

Question

How can I use my iconRemote to control my X10 lighting system?

Answer

If you own or purchase an X10 IR Command Console, Model IR543 and X10 Lamp, Appliance, and Wall Switch Modules you'll be able to control lights and appliances from your IR10A iconRemote. When you point the iconRemote at the IR543, it receives IR commands and converts them to X10 commands. Refer to page 34 and set up code 0401 under AUX (or any other mode you prefer). First, press the button on the remote for the mode you selected for X10. Second, press a number button on the iconRemote corresponding to the X10 Module you want to control. Finally, press one of these four buttons:

  • CHANNEL + to turn the module on
  • CHANNEL - to turn it off
  • VOLUME + to brighten Lamp and Wall Switch Modules
  • VOLUME - to dim Lamp and Wall Switch Modules.

You can also press the POWER button in the X10 mode to turn on ALL lights connected to Lamp and Wall Switch Modules and press MUTE to turn off all your X10 modules (including Appliance Modules).