Making a PowerHorn Macro

From X10Wiki
Revision as of 19:37, 20 May 2014 by X10douglas (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Question

How can I control a PowerHorn siren from ActiveHome Pro?

Answer

Plug in the PowerHorn siren.

Define an AM466 Three-Pin Appliance Module in ActiveHome Pro at the SAME address as the PowerHorn.

PH TEST.JPG

Build a Macro with a 'different Trigger Code' than the PowerHorn's address.

PH TRIG.JPGPH TRIG2.JPG

Put the following steps in the macro:

  • Delay 2 Seconds
  • Appliance Module On
  • Delay 2 Seconds
  • Appliance Module On

You should repeat this sequence of steps at least 4 times.

PH MACRO.JPG

After building this macro, go to the room in which it resides, then click its Run Macro button.

The siren should go off.

About 5 seconds after the macro finishes running, the siren should stop sounding.