Problems Setting Motion Sensors

From X10Wiki
Revision as of 22:07, 28 May 2014 by X10douglas (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search


What should I do when my VCR Commander will not accept Motion Sensor codes during programming?


If you have trouble programming a motion sensor code into your VCR Commander, try the following:

  • Put new batteries in each Motion Sensor.
  • Double-check that the Motion Sensor(s) has/have been programmed properly.

After verifying each of the above steps, clear the Motion Sensor memory in your VCR Commander and re-learn the X10 radio frequency codes.