Problems Setting Motion Sensors

From X10Wiki
Revision as of 23:32, 16 March 2006 by X10admin (talk | contribs)
Jump to navigation Jump to search


What should I do when my VCR Commander will not accept Motion Sensor codes during programming?

If you have trouble programming a motion sensor code into your VCR Commander, try the following:

  • Put new batteries in each Motion Sensor.
  • Double-check that the Motion Sensor(s) has/have been programmed properly.

After verifying each of the above steps, clear the Motion Sensor memory in your VCR Commander and re-learn the X10 radio frequency codes.

Related Articles