Protector Plus (DS7000) Message Dialer Quick Setup

Questions

How do I setup my security system?

How do I program phone numbers in the console?

Answer

Here are some quick instructions for setting up the telephone dialer.

• Set the console's INSTALL/RUN switch to INSTALL.
• Press the PROG button.
• Enter the first phone number that you want the console to call in the event of a problem, e.g. 234-5678.
• Press the MEM button.
• Press 1 to store the phone number in memory location 1.
• Press PROG and enter a second number, followed by pressing MEM and then 2 to store the number in memory location 2.
• Press PROG and enter a third number, followed by pressing MEM and then 3 to store the number in memory location 3.
• Press PROG and enter a fourth number, followed by pressing MEM and then 4 to store the number in memory location 4.
• Repeat steps 1-5 to change a number.
• When you are finished programming the numbers, move the console's INSTALL/RUN switch back to RUN.

If you want to store only one number, 'fill up' the memory locations with that number. Ex:

234-5678 memory location 1.

234-5678 memory location 2.

234-5678 memory location 3.

234-5678 memory location 4.

To store a voice message:

• Plug an earphone into the jack on the side of the console.
• Set the console's INSTALL/RUN switch to INSTALL.
• Press the RECORD button. The RECORD light turns on.
• Speak clearly into the microphone on the front of the console. You can record up to 15 seconds of speech. Ex: "This is Mrs Smith. There's a strange noise in my house. Press 0 to listen." After 15 seconds the RECORD light turns off.
• Set the console's INSTALL/RUN switch to RUN. The console plays back your message through the earphone so you can hear what it sounds like (it sounds better over the phone).
• If you want to hear the message again, set the console's INSTALL/RUN switch to INSTALL and then back to RUN.

Repeat all the steps if you want to change the message.