Setting EagleEye For Night Only

From X10Wiki
Revision as of 22:45, 13 September 2006 by Ericb (talk | contribs) (→‎Answer)
Jump to navigation Jump to search

Question

How do I set the EagleEye to only work at night?

Answer

To set whether you want the Motion Sensor to transmit EVERY time it sees motion or only at night:

Press the Unit/Off button once. The red light flashes. Then, (within 3 seconds) press and hold the House/On button. The green light turns on. 3 seconds later the Motion Sensor reports its dusk/dawn setting as follows:

The red light blinks once if the Motion Sensor is set to detect motion at all times.

The red light blinks twice if the Motion Sensor is set to detect motion only when it’s dark.

To change this, press the Unit/Off button once: the red light will flash. Then, within hree seconds, press and hold the House/On button. The green light turns on. Three seconds later the Motion Sensor reports its dusk/dawn setting, as listed above. Release and immediately press the House/On button once for operation at all times, or twice for operation only at night. Hold the button for three seconds on your last press. The red light then reports the setting with one or two blinks.