Setting Motion Off Delay Time For ActiveEye

Question

How do I set the Off Delay Time on my ActiveEye (MS16A) motion sensor?

Answer

You can set the delay time before your ActiveEye motion sensor sends an Off command after turning a module on. To check the current Off command delay time, press the House/On button once. The red LED light should flash. Press and hold the Unit/Off button. The green LED light turns on. 3 seconds later the red LED light reports the delay setting as follows:

• 1 blink for Analog: i.e. the setting on the dial on the top of the unit, from one to sixty minutes.
• 2 blinks for 2 minutes.
• 3 blinks for 4 minutes.
• 4 blinks for 8 minutes.
• 5 blinks for 16 minutes.
• 6 blinks for 32 minutes.
• 7 blinks for 64 minutes.
• 8 blinks for 128 minutes.
• 9 blinks for 256 minutes.

To change this, press the House/On button once. The red LED light will flash. Press and hold the Unit/Off button. The green LED light turns on. Three seconds later the red LED light reports the delay setting, as shown above. Release and immediately press the Unit/Off button the number of times for the delay you want. Hold the button for 3 seconds after the last press. The red LED light then reports the setting with the appropriate number of flashes. Release the button, and you are all set up.