Difference between revisions of "Using the Water Level Detector as a stand-alone item"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
| + | ==Question== | ||
| + | |||
| + | '''How do I use the water level Detector by itself? ''' | ||
| + | |||
| + | ==Answer== | ||
| + | |||
If you don’t own the SC1200 Security Console, then simply follow steps 1 through 3 | If you don’t own the SC1200 Security Console, then simply follow steps 1 through 3 | ||
below and the Water Level Detector is ready to use. It will beep whenever the sensor | below and the Water Level Detector is ready to use. It will beep whenever the sensor | ||
Revision as of 20:19, 21 January 2013
Question
How do I use the water level Detector by itself?
Answer
If you don’t own the SC1200 Security Console, then simply follow steps 1 through 3 below and the Water Level Detector is ready to use. It will beep whenever the sensor pad is immersed in water (and stop beeping about 15 seconds after you remove the sensor pad from the water).
Initializing Water Level Detectors
