Video Sender Interference
Why isn't the picture on my Video Sender clear?
Why do I only see white lines?
Other 2.4 GHz devices can distort the Video Transmitter and Receiver's picture and/or cause buzzing in the audio. If you are experiencing interference between the Video Transmitter and Receiver and some other equipment that uses 2.4 GHz, you might want to check the other device's owner's manual for the frequencies of each channel that it uses.
X10 cameras and Video Senders use the following frequencies:
- Channel A: 2.411 GHz
- Channel B: 2.434 GHz
- Channel C: 2.453 GHz
- Channel D: 2.473 GHz
We recommend using a frequency on the other device that is farthest from channel A or D, depending on which side of the band the other device is transmitting. You need to match the A-D switch on the Video Receiver with the one on the Video Transmitter.
If you are still experiencing interference, here are some suggestions for improving the signal.
- Move the Video Transmitter. If all else fails, walk around with it while someone else monitors your signal strength on your TV or PC.
- Change channels of your other 2.4 GHz devices. If you have a neighbor with a wireless network, you may be operating on the same channel. See if they would possibly change their frequency.
- If your phone is using a 2.4Ghz signal, you could possibly change phones. Consider one of the newer 5.8 GHz cordless phones or a 900MHz phone.
- If you are using an 802.11b wireless internet router/base-station, you might have better luck with the newer 802.11g devices that have more non-overlapping channels and much less interference. Plus, they are almost five times faster, leaving your X10 camera a much better chance of top quality reception.
- Check for wireless obstructions such as ceramic tile, concrete, brick, stucco--anything that can shorten the signal strength.