XCam2 and Vanguard ICC Setup
How do I set up my XCam2 cameras and Vanguard Internet Control Center?
Check for Parts
Make sure you have all these items:
If you have more than one camera, you should also have a TM751 transceiver module:
First, download and install Vanguard ICC using the link you received by e-mail. (If you didn't get an e-mail with the link in it, fill out our Secure Download Link Form.)
Click on the software link in the email you received titled "New Software Download Link." Before you download the software, choose the option to save the file, and save it onto your desktop so you can more easily access it later.
Disable or turn off your anti-virus software before you install the software as some anti-virus programs interfere with the installation. Remember to turn on your anti-virus program when you finish these steps.
Go to your desktop and double click the installation program you just downloaded. The software installation process will install the driver for your VA12A.
Once this is done you are ready to install the USB Video Adapter (model VA12A). Do not connect the USB Video Adapter before installing Vanguard ICC.
When the installation program instructs you to, plug the USB Video Adapter into a USB port located directly on the back of your computer:
The computer will recognize that new hardware has been installed and complete the installation. After the installation finishes, plug the CM19A FireCracker PC Transceiver into another USB port.
A) If you have more than one camera, set the House Code on the wireless transceiver module (model TM751), plug it into an AC outlet and extend the antenna.
B) If you have more than one camera, or a Ninja base, set the House Code on your remote control (model CR12A, or CR14A) and insert 4 AAA batteries. If the cameras are going to be units other than 1-4, follow the instructions that came in the remote’s box to change the scan controls.
C) Plug the receiver into wall power. Make sure the receiver is turned on; the power switch is next to the antenna hinge.
D) Connect the video receiver to the USB Video Adapter. Adjust the paddle-shaped so that it it faces in the general direction of all the cameras -- sometimes it may be best to point the antenna towards the ceiling.
E) Set up a camera. Set the House and Unit code on the addressable power supply as you chose above (see Getting Started).
Plug the power supply into a free AC outlet. Connect the camera to the power supply. The camera should come on and you should be able to get the picture on your PC. Adjust the antenna so that it points better at the antenna of the receiver. When the camera is set up, turn it off using the CR12A.
F) Repeat step E for each camera you are setting up.
Here is a full one-camera setup:
Run the Vanguard software. If you get an error message about the VA12A video adapter, please see this article. Register your software, click on the Option tab, then click on the Cameras subtab:
Click on Camera A1 then change the camera`s type to XCam2 or Ninja, as appropriate. If you have more than one camera, add an entry for each of your cameras, then click OK.
Here are some popular support resources for Vanguard: