Relabeling the Slimline Switch

From X10Wiki
Revision as of 20:31, 23 September 2010 by Ericb (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Question

How do I change the labels on my Slimline Switch?

Answer

To change the labels on your SS13A, first spread out a sheet of newspaper to provide a clean working area that will catch dropped bits. Remove the battery and its holder then carefully use a butter knife (or a similar thin flat blunt tool) to pop the entire SS13A case apart. Disassemble it, replace the labels, and carefully reassemble:

  1. Put the clear plastic covers back on the rubber part, covering the labels.
  2. Put the front of the switch face down and place the rubber bit in the holes. Make sure the red LED diffuser is still in plase.
  3. Put the circuit board over the rubber part, brown side up. The circuit board should sit against the two small plastic pins at the top of the case.
  4. Snap the back of the case back on, install the battery, and test the Slimline Switch.